Chemical analysis, chemistry, determination of the physical properties or chemical composition of samples of matter. A large body of systematic procedures intended for these purposes has been continuously evolving in close association with the development of other branches of the physical sciences since their beginnings.
Chemical analysis, which relies on the use of measurements, is divided into two categories depending on the manner in which the assays are performed. Classical analysis, also termed wet chemical analysis, consists of those analytical techniques that use no mechanical or electronic instruments other than a balance. The method usually relies on chemical reactions between the material being analyzed (the analyte) and a reagent that is added to the analyte. Wet techniques often depend on the formation of a product of the chemical reaction that is easily detected and measured. For example, the product could be coloured or could be a solid that precipitates from a solution.
Most chemical analysis falls into the second category, which is instrumental analysis. It involves the use of an instrument, other than a balance, to perform the analysis. A wide assortment of instrumentation is available to the analyst. In some cases, the instrument is used to characterize a chemical reaction between the analyte and an added reagent; in others, it is used to measure a property of the analyte. Instrumental analysis is subdivided into categories on the basis of the type of instrumentation employed.
Both classical and instrumental quantitative analyses can be divided into gravimetric and volumetric analyses. Gravimetric analysis relies on a critical mass measurement. As an example, solutions containing chloride ions can be assayed by adding an excess of silver nitrate. The reaction product, a silver chloride precipitate, is filtered from the solution, dried, and weighed. Because the product was formed by an exhaustive chemical reaction with the analyte (i.e., virtually all of the analyte was precipitated), the mass of the precipitate can be used to calculate the amount of analyte initially present.
